LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 950 (Engine Controls - 6.6L (Lb7) (Introduction)) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Valve Vent Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
  2. Disconnect the exhaust gas recirculation (EGR) valve vent solenoid electrical connector (1).
    3. Fig 1: EGR Valve Vent Solenoid Electrical Connector
    GM788837Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EGR vent solenoid vacuum lines (1).
    4. Fig 2: EGR Vent Solenoid Vacuum Lines
    GM788886Courtesy of GENERAL MOTORS CORP.
  4. Remove the EGR valve vent solenoid bolt (1) and solenoid.
    5. Fig 3: EGR Valve Vent Solenoid Bolt
    GM788889Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals