LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 950 (Engine Controls - 6.6L (Lb7) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the CMP sensor.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 8 N.m (71 lb in).

  3. Install the cooling fan pulley (2). Refer to Cooling Fan Pulley Replacement (6.6L (LB7) Engine) or Cooling Fan Pulley Replacement (6.6L (LLY) Engine) in Engine Cooling.
  4. Connect the CMP sensor electrical connector (1).
    5. Fig 1: View Of CMP Sensor Electrical Connector & Cooling Fan Pulley
    GM742170Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals