LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 949 (Steering Wheel And Steering Column) >> Repair Instructions >> Shift Lever Replacement (With Tow/Haul Switch) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift lever (1).
    Fig 1: Installing The Shift Lever (With Tow/Haul Switch)
    GM362445Courtesy of GENERAL MOTORS CORP.
  2. Connect the shifter electrical connector.
  3. Install the wire straps to the harness.
  4. Install the harness retaining pin (4) to the instrument panel.
    Fig 2: Installing Harness Retaining Pin To The Instrument Panel (With Tow/Haul Switch)
    GM748881Courtesy of GENERAL MOTORS CORP.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 3: Installing Knee Bolster Deflector Bracket And Nuts (With Tow/Haul Switch)
    GM748879Courtesy of GENERAL MOTORS CORP.
  5. Install the knee bolster deflector bracket and nuts (1).

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  6. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  7. Install the TORX® head shift lever screw.

    Tighten:  Tighten the screw to 20 N.m (15 lb ft).

  8. Roll the seal over the TORX® head shift lever screw.
  9. Install the 2 TORX® head screws to the lower column trim cover.
  10. Install the trim covers. Refer to Steering Column Trim Covers Replacement .
scientia non olet · About LEMON Manuals