LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 948 (Engine Controls - 8.1L (Introduction)) >> Repair Instructions >> Filler Tube Replacement (Cab/Chassis - Front) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caps from the fuel and vent openings in the tank.
  2. Install the fuel fill pipe and vent pipe to the tank.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Fuel Fill Pipe Clamp & Vent Pipe Clamp
    GM1228174Courtesy of GENERAL MOTORS CORP.
  3. Tighten the vent pipe clamp (1) at the tank.
  4. Tighten the fuel fill pipe clamp (2) at the tank.

    Tighten:  Tighten the clamps to 2.5 N.m (22 lb in).

    5. Fig 2: View Of Fuel Feed And Pressure Balance Lines
    GM1228187Courtesy of GENERAL MOTORS CORP.
  5. Remove the caps from the fuel feed and EVAP pipes.
  6. If equipped with a rear auxiliary tank, connect the fuel and EVAP quick connect fittings. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
scientia non olet · About LEMON Manuals