LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 948 (Engine Controls - 8.1L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Canister/Fuel Tank >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caps from the fuel and EVAP lines.
    Fig 1: EVAP Canister And Purge Line
    GM1306357Courtesy of GENERAL MOTORS CORP.
  2. Install the EVAP canister purge line (2). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  3. Install the EVAP canister line (1). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Install the EVAP canister. Refer to Evaporative Emission (EVAP) Canister Replacement (Pickup)  or Evaporative Emission (EVAP) Canister Replacement (Cab/Chassis) .
scientia non olet · About LEMON Manuals