LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 947 (Engine Controls - 4.8L, 5.3L, & 6.0L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caps from the EVAP canister purge solenoid and EVAP chassis pipe.
  2. Install the EVAP tube.
  3. Connect the EVAP tube to the EVAP chassis pipe (2).
  4. Connect the EVAP tube to the EVAP purge solenoid (1).
    5. Fig 1: EVAP Purge Solenoid & EVAP Chassis Pipe
    GM832127Courtesy of GENERAL MOTORS CORP.
  5. Install the engine sight shield. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L Engines) or Engine Sight Shield Replacement (6.0L Engine w/RPOs Y91 and Z88) in Engine Mechanical - 4.8L, 5.3L, and 6.0L.
scientia non olet · About LEMON Manuals