LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 947 (Engine Controls - 4.8L, 5.3L, & 6.0L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement (Pickup - 5.3L (L59) Engine) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EVAP vent valve with pipe.
  2. Install the EVAP pipe to the retaining clips.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the EVAP vent valve bracket bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  4. Close the pipe retaining clips.
    5. Fig 1: EVAP Vent Valve, Bracket, & Pipe (Pickup - 5.3L (L59))
    GM878143Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP vent valve electrical connector (1).
    6. Fig 2: EVAP Vent Valve Electrical Connector (Pickup - 5.3L (L59))
    GM815635Courtesy of GENERAL MOTORS CORP.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals