LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 947 (Engine Controls - 4.8L, 5.3L, & 6.0L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement (1500 Crew Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EVAP canister to the bracket, if necessary.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EVAP canister bracket bolts.

    Tighten:  Tighten the bolts to 18 N.m (13 lb ft).

    3. Fig 1: EVAP Canister & Bolts
    GM1223729Courtesy of GENERAL MOTORS CORP.
  3. Connect the fuel tank line to the EVAP canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Connect the fuel/EVAP bundle line to the EVAP canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  5. Connect the CVS line to the EVAP canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    6. Fig 2: CVS (1500 Crew Cab)
    GM1223732Courtesy of GENERAL MOTORS CORP.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals