LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 947 (Engine Controls - 4.8L, 5.3L, & 6.0L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the insulator (1) onto the EVAP canister purge solenoid (3).
  2. Install the EVAP canister purge solenoid (3).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the EVAP canister purge solenoid bolt (2).

    Tighten:  Tighten the bolt to 10.5 N.m (93 lb in).

    4. Fig 1: View Of EVAP Purge Solenoid Bolt, Solenoid & Isolator
    GM389993Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister purge solenoid electrical connector (1).
    5. Fig 2: View Of EVAP Canister Purge Solenoid & Generator Electrical Connectors & Bracket Nut
    GM1235683Courtesy of GENERAL MOTORS CORP.
  5. Install the EVAP line to the canister purge solenoid (1).
    6. Fig 3: EVAP Purge Solenoid & EVAP Chassis Pipe
    GM832127Courtesy of GENERAL MOTORS CORP.
  6. Install the engine sight shield. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L Engines) or Engine Sight Shield Replacement (6.0L Engine w/RPOs Y91 and Z88) in Engine Mechanical - 4.8L, 5.3L, and 6.0L.
scientia non olet · About LEMON Manuals