LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Automatic Transmission - Servicing - Except ALLISON) >> Removal & Installation >> 2-4 Servo (4L60-E) >> Adjustment

2-4 Servo (4L60-E): Adjustment

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, and 2002 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the band apply pin and the band apply pin tool. Install the servo cover retaining ring to secure the tool. See Figure.
  2. Apply 98 INCH lbs. (11 N.m) torque. If the White line appears in the gauge slot, the pin length is correct. See Figure.
  3. If the White line is not seen in the slot, replace the pin using the following pin identification:
    • One groove, pin length 2.59-2.60" (65.82-66.12 mm).
    • Two grooves, pin length 2.65-2.66" (67.23-67.53 mm).
    • No grooves, pin length 2.70-2.71" (68.64-68.94 mm).
  4. Remove the pin and the band apply pin tool.
  5. Check the 2nd apply piston and the housing dimension. Measure the piston dimension. Measure the housing dimension. See Figure.
  6. Check the table for the transmission and piston/housing specifications.
scientia non olet · About LEMON Manuals