LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 939 (Manual Transmission -- ZF S6-650) >> Repair Instructions >> Transmission Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The J 44732  will set the oil seal to the proper depth. Failure to use the J 44732  will cause improper installation of the oil seal.
  1. Using J 44732  install the rear oil seal.
    Fig 1: Installing The Rear Oil Seal
    GM696798Courtesy of GENERAL MOTORS CORP.
    2. Fig 2: Installing Yoke
    GM661231Courtesy of GENERAL MOTORS CORP.
  2. Install the yoke.
  3. Use the J 8614-01  in order to hold the yoke.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install a NEW yoke nut.

    Tighten:  Tighten the nut to 330 N.m (244 lb ft).

  5. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece or Propeller Shaft Replacement - Two Piece in Propeller Shaft.
  6. Check the transmission fluid level. Add if necessary.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals