Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: Installing The Backup Lamp Switch

Courtesy of GENERAL MOTORS CORP.

Install the backup lamp switch.
Tighten: Tighten the switch to 20 N.m (15 lb ft).

Fig 2: Connecting The Backup Lamp Switch Electrical Connector (8.1L Engine)

Courtesy of GENERAL MOTORS CORP.

If equipped with a 8.1L engine, connect the backup lamp switch electrical connector (4).

Fig 3: Connecting The Backup Lamp Switch Electrical Connector (6.6L Engine)

Courtesy of GENERAL MOTORS CORP.

If equipped with a 6.6L engine, connect the backup lamp switch electrical connector (3).
Lower the vehicle.