LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 937 (Manual Transmission -- NV 3500) >> Repair Instructions >> Transmission Housing Oil Seal Replacement - Rear (4WD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the J 36502-2A  over the output shaft.
    Fig 1: Positioning The J 36502-2A Over The Output Shaft
    GM4757Courtesy of GENERAL MOTORS CORP.
  2. Using J 36502  install the NEW output shaft seal.
    Fig 2: Install The New Output Shaft Seal
    GM4758Courtesy of GENERAL MOTORS CORP.
    3. Fig 3: Removing The J 36502-2A From The Output Shaft
    GM4757Courtesy of GENERAL MOTORS CORP.
  3. Remove the J 36502-2A  from the output shaft.
    4. Fig 4: Filling The Space Between The Seal Lips With Grease GM P/N 1052497
    GM7909Courtesy of GENERAL MOTORS CORP.
  4. Fill the space between the seal lips with grease GM P/N 1052497 or equivalent.
  5. Install transfer case. Refer to Transfer Case Assembly Replacement in Transfer Case - NVG 236/246-NP8 (Two Speed Automatic) or Transfer Case Assembly Replacement in Transfer Case - NVG 261-NP2 (Two Speed Manual).
  6. Check the transmission fluid level. Add as necessary.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals