LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Panel Replacement - Instrument Panel (I/P) Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
    2. Fig 1: Connecting Ambient Light Sensor Electrical Connector
    GM350507Courtesy of GENERAL MOTORS CORP.
  2. Install the trim panel to the IP assembly.
    3. Fig 2: Installing I/P Assembly Upper Trim Panel
    GM348717Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the trim panel retaining screws.

    Tighten:  Tighten the trim panel retaining screws to 2 N.m (18 lb in).

  4. Install the windshield pillar garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
  5. Align the assist handle with the holes in the IP assembly. Push the handle in order to engage the retaining tabs.
    6. Fig 3: Installing Assist Handle
    GM348728Courtesy of GENERAL MOTORS CORP.
  6. Install the right side air outlets.
  7. Install the end panels. The left panel is shown, and the right panel is similar.
    8. Fig 4: Installing End Panel
    GM348724Courtesy of GENERAL MOTORS CORP.
  8. Install the IP cluster trim plate bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster .
  9. Tilt the steering wheel to the normal driving position.
  10. If the transmission is automatic, move the shift lever to the park position.
  11. Disengage the parking brake.
scientia non olet · About LEMON Manuals