LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel (I/P) Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the I/P carrier. Refer to Instrument Panel (I/P) Carrier Replacement .
  2. Remove the driver's side hinge pillar trim panel. Refer to Trim Panel Replacement - Hinge Pillar in Interior Trim.
  3. Remove the driver's side seat, if equipped with power. Refer to Seat Replacement - Front Bucket .
  4. Disconnect the electrical harness from the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement .
  5. Disconnect the wire harness from the hood, if equipped with underhood camp.
  6. Remove the harness grommet from the cowl.
  7. Remove the I/P harness from the vehicle.
    8. Fig 1: I/P Harness
    GM603160Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals