Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the console to the bracket.
- Install the fasteners retaining the console to the bracket.
Tighten: Tighten the fasteners to 2 N.m (17 lb in).
- Install the amplifier and bracket to the console bracket. Refer to Amplifier Replacement in Entertainment.
- Install the console bin. Refer to Console Storage Bin Replacement (Expect Pro) or Console Storage Bin Replacement (Pro) .
- Install the rear seat audio control to the console, if equipped. Refer to Audio Control Replacement - Rear Seat in Entertainment.
- Install the console in the vehicle.
- Connect the wire connectors.
- Move the console forward in order to install the retaining screws.
- Install the 2 screws.
Tighten: Tighten the screws to 4 N.m (35 lb in).
- Install the cupholder to the console. Refer to Cupholder Replacement (Luxury) , Cupholder Replacement (Non-Luxury) , Cupholder Replacement (Rear) or Cupholder Replacement (Pro) .
- Install the upper console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper) , Bezel Replacement - Floor Console (Luxury Upper) or Bezel Replacement - Floor Console (Non-Luxury Lower) .
- Install both front seats. Refer to Seat Replacement - Front Bucket in Seats.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.