LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Instrument Panel System Displays, Gauges And Console) >> Diagnostic Information and Procedures >> Volt Gage Inaccurate or Inoperative

Volt Gage Inaccurate or Inoperative

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Volt Gage Inaccurate or Inoperative

Step Action Yes No
Schematic Reference: Instrument Cluster Schematics 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Instrument Cluster 
2
  1. Turn the ignition ON, with the engine OFF.
  2. Install a scan tool.
  3. With the scan tool, perform the Displays Test in the IPC scan tool Output Controls.
Does the gage move from 0 to its maximum value and back to 0 when you perform the Displays Test?		 Go to Step 3  Go to Step 4 
3
  1. Install a scan tool.
  2. Start the engine.
  3. With the scan tool, observe the Battery Voltage parameter in the BCM Data list.
Does the Battery Voltage parameter match the gage display?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 4 
4
IMPORTANT: Program the replacement IPC.
Replace the instrument panel cluster (IPC). Refer to Instrument Panel Cluster (IPC) Replacement .Did you complete the replacement?		 Go to Step 5  -
5
  1. Use the scan tool in order to clear any induced DTCs.
  2. Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About LEMON Manuals