Remote Playback Device - Audio Noise
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Remote Playback Device - Audio Noise
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Radio/Audio System Schematics (Base/Uplevel Radio - UQ3/UQ5) Radio/Audio System Schematics (Premium Radio - UQ7 w/o Y91) Radio/Audio System Schematics (Luxury Radio - UQ7 w/Y91) | |||
| 1 | Did you perform the Diagnostic System Check-Entertainment System? | Go to Step 2 | Go toDiagnostic System Check - Entertainment System |
| 2 |
|
Go toTesting for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 9 | Go to Step 4 |
| 4 | Test the remote playback device audio common signal circuit of the remote playback device for a short, high resistance, or an open. Refer toCircuit Testing
andWiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 5 |
| 5 | Inspect the audio harness shield of the remote playback device for damage. Refer toCircuit Testing
andWiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 6 |
| 6 | Inspect for poor connections at the harness connector of the remote playback device. Refer toTesting for Intermittent Conditions and Poor Connections
andConnector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 7 | Inspect for poor connections at the harness connector of the radio. Refer toTesting for Intermittent Conditions and Poor Connections
andConnector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 8 | Replace the remote playback device. Refer toRemote CD Player Replacement . Did you complete the replacement? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |