LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 930 (Entertainment System) >> Diagnostic Information and Procedures >> Noise Compensated Volume Inoperative

Noise Compensated Volume Inoperative

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Noise Compensated Volume Inoperative

Step Action Value Yes No
Schematic Reference: Radio/Audio System Schematics (Base/Uplevel Radio - UQ3/UQ5) Radio/Audio System Schematics (Premium Radio - UQ7 w/o Y91) Radio/Audio System Schematics (Luxury Radio - UQ7 w/Y91) 
1 Did you perform the Diagnostic System Check - Entertainment System? - Go to Step 2  Go to Diagnostic System Check - Entertainment System 
2
  1. Turn ON the ignition, with the engine ON.
  2. Turn ON the blower motor on the maximum speed.
  3. Cycle the auto volume control ON and then OFF.
Is a difference in volume heard?
- Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3
  1. Turn ON the ignition, with the engine OFF.
  2. Disconnect the noise compensation microphone.
  3. Measure the voltage from the noise compensation microphone supply voltage circuit to the drain wire.
Does the voltage measure near the specified value?
8 V Go to Step 4  Go to Step 5 
4 Replace the noise compensation microphone. Refer to Microphone Replacement - Radio Volume Compensator Interior .
Did you complete the replacement?
- Go to Step 9  -
5 Test the noise compensation microphone supply voltage circuit for an open or short. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
- Go to Step 9  Go to Step 6 
6 Test the drain wire circuit for an open or short. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
- Go to Step 9  Go to Step 7 
7 Inspect for poor connections at the amplifier. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
- Go to Step 9  Go to Step 8 
8 Replace the amplifier. Refer to Amplifier Replacement .
Did you complete the repair?
- Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?
- System OK Go to Step 3