LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Automatic Transmission Servicing) >> Removal & Installation >> Output Shaft (4T65-E) >> Installation

Output Shaft (4T65-E): Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive axle retaining ring and the output shaft differential inboard snap ring onto the output shaft. See Figure . Install the fourth clutch bearing onto the output shaft.
  2. Hold the front differential carrier in place and carefully install the output shaft into the transaxle through the left wheel opening. See Figure .
  3. Extend the output shaft through the differential side gear. Install the case extension housing. See CASE EXTENSION HOUSING (4T65-E)  .
scientia non olet · About LEMON Manuals