Accumulator & 2-1 Manual Servo (4T65-E): Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- If disassembled, assemble the 2-1 band servo. See appropriate OVERHAUL article in AUTOMATIC TRANSMISSIONS. Install the manual 2-1 band servo. The seal must be installed as shown. If it is not installed, or is installed in the wrong location, the transaxle will operate only in Reverse. See Figure .
- Install the lube oil pipe to the front differential carrier internal gear lube hole. See Figure . Position the manual 2-1 band servo cover and accumulator into place.
- Install the manual 2-1 band servo cover bolts. Tighten the manual 2-1 band servo cover bolts to specification. Install the accumulator attaching bolts. Tighten the accumulator attaching bolts to specification. See TORQUE SPECIFICATIONS .
- If removed, install the new filter seal. Install the filter. Install the oil pan. See DRAINING & REFILLING (4T65-E) under LUBRICATION. Lower the vehicle. Fill transaxle with appropriate fluid to proper level. See LUBRICATION .