1-2 Shift Solenoid Valve (4T65-E): Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Install a new O-ring seal (316) onto the 1-2 shift solenoid valve (315A), if it was removed. See Figure . Install the 1-2 shift solenoid valve (315A). Connect the transaxle wiring harness. Hold the 1-2 shift solenoid valve (315A) in the control valve body (301). Install the 1-2 shift solenoid valve retainer (314D) into the control valve body (301). Install the case side cover. See CASE SIDE COVER (4T65-E) .