LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 919 (Body Rear End) >> Repair Instructions >> Lock Striker Replacement - End Gate (Pickup) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pickup box endgate striker to the vehicle.
  2. Install the nuts that retain the pickup box endgate striker to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the bolts that retain the pickup box endgate striker to the vehicle.

    Tighten 

    Tighten the bolts to 25 N.m (18 lb in).

  4. Connect the pickup box endgate cable to the endgate striker bolt.
  5. Install the tail lamp. Refer to TAIL LAMP ASSEMBLY AND/OR BACKUP, SIDEMARKER, STOP, TURN SIGNAL BULB REPLACEMENT (PICKUP) or TAIL LAMP ASSEMBLY AND/OR BACKUP, SIDEMARKER, STOP, TURN SIGNAL BULB REPLACEMENT (UTILITY) in Lighting Systems.
    Fig 1: Pickup Box Endgate Striker
    G01478287Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals