LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 919 (Body Rear End) >> Repair Instructions >> Handle Replacement - Rear Door Inside >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the endgate handle assembly on the endgate.
  2. Install the endgate handle assembly to the endgate with 2 rivets using a J 34940. 
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the screws that retain the inside handle to the endgate handle assembly.

    Tighten 

    Tighten the screws to 2.8 N.m (25 lb in).

    Fig 1: Installing Endgate Handle Assembly To Endgate
    G01478252Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals