LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 918 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Body Side (4-Door Utility) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the body side trim panel to the vehicle.
  2. Feed the seat belt through the trim panel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the screws that retain the body side trim panel to the vehicle (left side only).

    Tighten 

    Tighten the screws to 1.9 N.m (17 Ib ft).

  4. Install the spare tire and the carrier assembly (if equipped).
  5. Install the jack storage cover (left side only).
  6. Install the endgate or liftgate opening door sill trim plate. Refer to DOOR SILL PLATE REPLACEMENT - END GATE  or DOOR SILL PLATE REPLACEMENT - LIFT GATE .
    Fig 1: Installing Body Side Trim Panel To Vehicle
    G01478181Courtesy of GENERAL MOTORS CORP.
  7. Install the upper and lower rear seat belt anchor bolts.

    Tight n 

    • Tighten the upper bolts to 70 N.m (52 Ib ft).
    • Tighten the lower bolts to 80 N.m (59 Ib ft).
scientia non olet · About LEMON Manuals