LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 912 (Exterior Trim) >> Repair Instructions >> Wheel Opening Flare Replacement -Front (Xtreme) >> Tools Required >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use a heat gun J 25070  in a circular motion for 30 seconds 152 mm (6 in) from the surface in order to heat the edge of the fender to 21-32°C (70-90°F).

    Important:  Do not touch the adhesive backing on the molding.

  2. Remove the protective liner from the back side of the wheel opening flare.
  3. Install the wheel flare to the vehicle fender.

    Apply firm and even pressure in order to properly seat the adhesive.

    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the screws that retain wheel flare to the vehicle.

    Tighten 

    Tighten the front wheel opening flare screws to 1.9 N.m (17 lb in).

  5. Lower the vehicle.
    Fig 1: Installing Wheel Flare To Vehicle Retaining Screws
    G01477343Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals