Equipment and Materials
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
The following equipment and materials are necessary when making a quality stripe or decal installation:
- J 25070 Heat Gun
- Wetting solution -a foaming type window cleaner, that does not contain ammonia
- Isopropyl alcohol
- Varnish Makers and Painters (VM&P) naphtha
- Squeegee -100 mm (4 in) wide, plastic or hard rubber
Deburr any sharp or rough edges on the squeegee to prevent scratching of the stripe or decal.
- Water bucket and sponge or spray bottle
- Sandpaper -800 grit or finer, wet or dry type
- Clean, lint-free wiping cloth
- Sharp knife or razor blade
- Scissors
- Fine pin or needle
- Marking pencil