Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- Position the instrument panel accessory trim plate in order to install the control switches.
- Install the selectable 4WD switch, if equipped. Refer to TRANSFER CASE SHIFT CONTROL SWITCH REPLACEMENT or TRANSFER CASE SHIFT CONTROL SWITCH REPLACEMENT in Transfer Case.
- Install the inflatable restraint IP module switch. Refer to INFLATABLE RESTRAINT INSTRUMENT PANEL (I/P) MODULE DISABLE SWITCH REPLACEMENT in SIR.
- Install the headlamp switch. Refer to HEADLAMP SWITCH REPLACEMENT in Lighting Systems.
- Install the instrument panel accessory trim plate clips to the instrument panel.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the screws that retain the instrument panel accessory trim plate to the instrument panel.
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
- Install the knee bolster trim panel. Refer to TRIM PANEL REPLACEMENT - KNEE BOLSTER .
- Install the left instrument panel sound insulator. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - LEFT .