LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 901 (Wiring Systems (General Information)) >> Repair Instructions >> Relay Replacement (Within an Electrical Center) >> Tools Required >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the electrical center cover.
  2. Locate the relay. Refer to ELECTRICAL COMPONENT LOCATOR to locate the electrical center where the relay exists.

    Important: 

    • Always note the orientation of the relay.
    • Ensure that the electrical center is secure, as not to put added stress on the wires or terminals.
  3. Using the J 43244  (1) position the tool on opposing corners of the relay (2).
    NOTE: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.
  4. Remove the relay (2) from the electrical center.
    Fig 1: Removing Relay (With In Electrical Center) Using Puller Plier
    G01534699Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals