LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 901 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Push to Seat Connectors >> Terminal Removal

Terminal Removal

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

Fig 1: Separating Push To Seat Connectors Halves
G01534693Courtesy of GENERAL MOTORS CORP.
  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. Separate the connector halves (1).
    Fig 2: Pulling Cable & Terminal Out Of Back Of Connector
    G01534694Courtesy of GENERAL MOTORS CORP.
  3. Use the proper pick or removal tool (1) in order to release the terminal.
  4. Gently pull the cable and the terminal (2) out of the back of the connector.
    Fig 3: Re-Forming Locking Device
    G01534695Courtesy of GENERAL MOTORS CORP.
  5. Re-form the locking device if you are going to reuse the terminal (1).
  6. To repair the terminal, refer to Terminal Repair.
scientia non olet · About LEMON Manuals