Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Coat a new O-ring seal with a thin film of transmission oil.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the following parts:
1. 2.1. The O-ring on the vehicle speed sensor assembly.
2. 2.2. The vehicle speed sensor assembly.
3. 2.3. Tighten
  Tighten the bolt to 16 N.m (12 lb ft).
  
  Fig 1: O-Ring Seal
  Courtesy of GENERAL MOTORS CORP.
Install the electrical connector to the vehicle speed sensor.
Lower the vehicle.

Fig 2: Vehicle Speed Sensor
Courtesy of GENERAL MOTORS CORP.