LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 898 (Manual Transmission Clutches) >> Repair Instructions >> Clutch Master Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the master cylinder rod from the clutch pedal.
    Fig 1: Removing Master Cylinder Rod From Clutch Pedal
    G01980119Courtesy of GENERAL MOTORS CORP.
  2. Turn the master cylinder 45 degrees clockwise to unlock the master cylinder.
  3. Disconnect the wiring harness from the clutch master cylinder start switch.
    Fig 2: Turning Master Cylinder 45 Degrees Clockwise To Unlock Master Cylinder
    G01980120Courtesy of GENERAL MOTORS CORP.
  4. Remove the clips securing the clutch line to the dash panel and heat shield.
  5. Remove the clutch master cylinder from the dash panel.
  6. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
    Fig 3: Removing Clips Securing Clutch Line To Dash Panel And Heat Shield
    G01980121Courtesy of GENERAL MOTORS CORP.
  7. Using the J 42371  remove the clutch line from the concentric slave cylinder.
  8. Lower the vehicle.
  9. Remove the clutch master cylinder.
    Fig 4: Clutch Master Cylinder
    G01980122Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals