LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 885 (Engine Mechanical - 4.3L (LU3)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Pan Replacement (2WD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine. Refer to Engine Replacement  .
  2. Remove the oil pan drain plug and drain the engine oil into a suitable container.

    Important:  The low oil level sensor is not reusable. Use a NEW low oil sensor.

  3. Remove and discard the engine oil level sensor (if applicable).
    Fig 1: Removing Engine Oil Level Sensor
    G01977612Courtesy of GENERAL MOTORS CORP.
  4. Remove the oil pan bolts and nuts.
    Fig 2: Identifying Oil Pan Bolts & Nuts
    G01977613Courtesy of GENERAL MOTORS CORP.
  5. Remove the oil pan.
    Fig 3: Removing Oil Pan
    G01977614Courtesy of GENERAL MOTORS CORP.
  6. Remove the oil pan gasket.
  7. Discard the oil pan gasket.
  8. Clean all sealing surfaces on the engine and the oil pan. Refer to Oil Pan Cleaning and Inspection  .
    Fig 4: Removing Oil Pan Gasket
    G01977615Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals