LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 882 (Transfer Case - NVG 236/246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transfer case rear output shaft seal in the transfer case with your fingers.
  2. Using the J 37668-A,  install the transfer case rear output shaft seal.
  3. Install the rear propeller shaft in to the transfer case.
    • For vehicles equipped with the one piece propeller shaft, refer to PROPELLER SHAFT REPLACEMENT - ONE PIECE in Propeller Shaft.
    • For vehicles equipped with the two piece propeller shaft, refer to PROPELLER SHAFT REPLACEMENT - TWO PIECE in Propeller Shaft.
    • Check the transfer case fluid level. Refer to TRANSFER CASE FLUID REPLACEMENT .
  4. Install the transfer case shield to the vehicle. Refer to TRANSFER CASE SHIELD REPLACEMENT  .
  5. Lower the vehicle. Refer to JACKING AND LIFTING in General Information.
    Fig 1: Installing Transfer Case Rear Output Shaft Seal
    G01468414Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals