LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 882 (Transfer Case - NVG 236/246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Motor/Encoder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Important:  When performing this service procedure, make sure that the motor/encoder unit is flat against the transfer case for proper installation.

  1. Install the motor/encoder to the transfer case.
  2. Install the motor/encoder gasket to the transfer case.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install motor/encoder mounting bolts to the transfer case.

    Tighten 

    Tighten the motor/encoder mounting bolts to 20 N.m (15 lb ft).

    Fig 1: Installing Motor/Encoder Mounting Bolts To Transfer Case
    G01468398Courtesy of GENERAL MOTORS CORP.
  4. Install the motor/encoder electrical connector.
  5. Install the transfer case shield. Refer to TRANSFER CASE SHIELD REPLACEMENT  .
  6. Lower the vehicle. Refer to JACKING AND LIFTING in General Information.
    Fig 2: Installing Motor/Encoder Electrical Connector
    G01468399Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals