Diagnostic Aids

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Inspect wiring for poor connections. Check for bent, backed out or damaged terminals, or poor terminal tension. Check for chafed wire or broken wire inside insulation. When diagnosing intermittent condition, wiggle wiring harness while watching scan tool for change in value.

Drive the vehicle if necessary to experience a fault.

This DTC could indicate a hydraulic leak path exhausting pressure from the Reverse pressure switch.

Multiple inactive pressure switch DTCs may be due to a plugged control main filter. Ensure that the initial 5000-mile filter change was performed.

An inactive DTC P0875 (previously P1713) set in combination with DTC P0872 (previously P1711) often indicates that an internal PNP switch failure occurred on a previous drive cycle. If this combination returns after clearing DTCs, replacement of the PNP switch may be necessary.