LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 854 (Body Front End) >> Repair Instructions >> Brace Replacement - Front Fender Upper Diagonal - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Reposition the underhood wiring junction block from the front fender diagonal brace. Refer to UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT .
    Fig 1: Repositioning Underhood Wiring Junction Block From Front Fender Diagonal Brace
    G01515891Courtesy of GENERAL MOTORS CORP.
  3. Remove the bolt from the front end sheet metal diagonal brace at the inner fender.
  4. Remove the bolts from the front end sheet metal diagonal brace at the radiator support.
    Fig 2: Removing Front End Sheet Metal Diagonal Brace Bolts
    G01515892Courtesy of GENERAL MOTORS CORP.
  5. Remove the front end sheet metal diagonal brace.
    Fig 3: Removing Front End Sheet Metal Diagonal Brace
    G01515893Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals