LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 853 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Repair Instructions >> Case Porosity >> Repair Procedure

Repair Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use solvent to clean the leak area.
  2. Use compressed air to dry the area.
    CAUTION: Epoxy adhesive may cause skin irritations and eye damage. Read and follow all information on the container label as provided by the manufacturer.
  3. Follow the manufacturer's recommendations to mix a sufficient amount of GM P/N 1052533, or equivalent, epoxy cement.
  4. Use a clean and dry soldering acid brush to apply the epoxy cement while the transaxle case is hot.
  5. Allow the epoxy cement to cure for three hours.
  6. Start the engine.
  7. Repeat the fluid leak diagnosis procedures.
scientia non olet · About LEMON Manuals