LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 853 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Repair Instructions >> Automatic Transmission Oil Cooler Fitting Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Allow sufficient clearance around the transaxle oil cooler pipes and around the hoses to prevent damage or wear which may cause fluid loss.
  1. Raise and support the vehicle.
  2. Position the drain pan.
  3. Remove the transaxle oil cooler hoses from the transaxle oil cooler fittings. Refer to AUTOMATIC TRANSMISSION OIL COOLER HOSE REPLACEMENT  .
  4. Remove the transaxle oil cooler fittings (28, 29) from the transaxle.
    Fig 1: Removing Transaxle Oil Cooler Fittings From Transaxle
    G01502047Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals