LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 853 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Repair Instructions >> Automatic Transmission Brace Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transaxle brace to transaxle and engine.
  2. Hand start the bolts to the engine.
  3. Hand start the bolts to the transaxle.
  4. Install the brace bolts to the engine.

    Tighten 

    Tighten the brace bolts to 43 N.m (32 lb ft).

  5. Install the brace bolts to the transaxle.

    Tighten 

    Tighten the brace bolts to 43 N.m (32 lb ft).

  6. Install the right engine splash shield. Refer to SPLASH SHIELD REPLACEMENT -- ENGINE .
  7. Install the right front tire and wheel.
  8. Lower the vehicle.
    Fig 1: Installing Transaxle Brace Bolts
    G01502052Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals