LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 853 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Diagnostic Information and Procedures >> Flexplate/Torque Converter Vibration Test >> Installing Torque Converter

Installing Torque Converter

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle.
    Fig 1: Installing Torque Converter
    G01501833Courtesy of GENERAL MOTORS CORP.
  2. Align the torque converter pilot (2) in the engine crankshaft (3) and slide the torque converter up against the flywheel.
  3. Lower the vehicle.
  4. With the engine at idle speed and the transmission in PARK or NEUTRAL, observe the vibration.

    Refer to NOISE AND VIBRATION ANALYSIS  .

    Repeat this procedure until you obtain the best possible balance.

  5. Install the transmission converter cover bolts and the cover.

Refer to TORQUE CONVERTER COVER REPLACEMENT  .

scientia non olet · About LEMON Manuals