LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 843 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rocker molding to the holes in the rocker panel.
  2. Install the rocker molding starting to the first net hole (1) then the second net hole (2) and then the third net hole (3). Press the push-in retainers into place until fully seated.
  3. Install the push-in retainers to the lower rocker molding, pressing into place until fully seated.
    Fig 1: Installing Push-In Retainers To Lower Rocker Molding
    G01515673Courtesy of GENERAL MOTORS CORP.
  4. Install the rocker molding screw to the rocker molding.

    Tighten 

    Tighten the screw to 6 N.m (53 lb in).

    Fig 2: Installing Rocker Molding Screw To Rocker Molding
    G01515674Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals