LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 843 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Lift Gate Upper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lift gate applique. Refer to LIFT GATE APPLIQUE REPLACEMENT .
  2. Remove the lift gate handle. Refer to HANDLE REPLACEMENT -- END GATE .
  3. Remove the lift gate lower molding. Refer to MOLDING REPLACEMENT - LIFT GATE LOWER  .
  4. Remove the screws from the lift gate upper molding.
    Fig 1: Removing Screws From Lift Gate Upper Molding
    G01515656Courtesy of GENERAL MOTORS CORP.
  5. Remove the lift gate upper molding from the lift gate.
    Fig 2: Removing Lift Gate Upper Molding
    G01515657Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals