LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 843 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Lift Gate Lower >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the lift gate lower molding to the tabs in the upper molding.
    Fig 1: Aligning Lift Gate Lower Molding To Tabs In Upper Molding
    G01515661Courtesy of GENERAL MOTORS CORP.
  2. Install the lift gate lower molding screws.

    Tighten 

    Tighten the screws to 2.0 N.m (18 lb in).

  3. Close the rear lift gate.
    Fig 2: Installing Lift Gate Lower Molding Screws
    G01515662Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals