LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 843 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Wheel Opening (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front wheel liner. Refer to FRONT FENDER LINER REPLACEMENT .
  2. Remove the bolts from the corner of the front fascia. Refer to FASCIA REPLACEMENT -- FRONT BUMPER -- UPPER (AZTEK) or FASCIA REPLACEMENT -- FRONT BUMPER -- UPPER (RENDEZVOUS) .
  3. Remove the screws from the front wheel opening molding.
    Fig 1: Removing Screws From Front Wheel Opening Molding
    G01515598Courtesy of GENERAL MOTORS CORP.
  4. Pull the corner of the front fascia outward to access the front retainer on the wheel opening molding.
  5. Use a thin, plastic flat-bladed tool between the fender and the molding to help release the retainers.

    Remove the molding from the fender.

    Fig 2: Removing Molding From Fender
    G01515599Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals