LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 843 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Door Body Side (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the support retainer with the notch down and the retainers to the holes in the door panel.
    Fig 1: Positioning Support Retainer With Notch Down & Retainers To Holes In Door Panel
    G01515628Courtesy of GENERAL MOTORS CORP.
  2. Install in the center pins of the retainers using a small hammer.
  3. Position the lower flange of the front door body side molding to the retainer support and align the tab to the notch in the retainer support.
  4. Position the upper edge of the front door body side molding retainer clips to the holes in the door panel.
  5. Install the retainer clips to the door panel by pressing in until fully seated.
  6. Close the front door.
    Fig 2: Installing In Center Pins Of Retainers
    G01515629Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals