LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 843 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Door (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the location of the emblem/nameplate has not been marked apply tape and use the following dimensions:
    • Dimension (a) is 19.5 mm (0.78 in) above the feature line on the door.
    • Dimension (b) is 68.7 mm (2.7 in) from the front edge of the door.
    Fig 1: Locating Dimensions For Installing Emblem
    G01515583Courtesy of GENERAL MOTORS CORP.
  2. Warm the door surface with a heat gun J 25070  152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).

    Important:  Do not touch the adhesive backing of the emblem/nameplate.

  3. Remove the backing from the front end of the emblem/nameplate.
  4. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
  5. Hand roll the emblem/nameplate to the door panel to ensure paper adhesion.
  6. Inspect the emblem/nameplate for bonding.
  7. Remove the tape from the area around the door emblem.
    Fig 2: Heating Liftgate Surface
    G01515584Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals