Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Important: Protect the trim panel at the point of insertion of the flat bladed tool to avoid damaging the door panel.

Use a small flat-bladed tool to remove the mounting plate for the power window switch. Insert the tool at the rear of the mounting plate and release the retainer.

Fig 1: Removing Rear Door Power Window Switch (Rendezvous - 1 Of 3)
Courtesy of GENERAL MOTORS CORP.
Lift the rear of the switch plate.

Fig 2: Removing Rear Door Power Window Switch (Rendezvous - 2 Of 3)
Courtesy of GENERAL MOTORS CORP.
Disconnect the electrical connector.
Remove the power window switch from the mounting plate.

Fig 3: Removing Rear Door Power Window Switch (Rendezvous - 3 Of 3)
Courtesy of GENERAL MOTORS CORP.