LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 841 (Steering Wheel & Steering Column) >> Repair Instructions >> Wire Harness Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The wheels of the vehicle must be straight ahead and the steering column in the LOCK position before disconnecting the steering column or intermediate shaft from the steering gear. Failure to do so will cause the SIR coil assembly to become uncentered, which may cause damage to the coil assembly.
  1. Remove the steering column. Refer to STEERING COLUMN REPLACEMENT  .
  2. Disconnect all the electrical connectors.
  3. Remove all the wire harness straps (2).
  4. Remove the wire harness from the steering column.
    Fig 1: Removing Wire Harness From Steering Column
    G01499466Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals