LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 834 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (RPO LQ4)) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the sight shield retainer and the bolts, if required.

    Tighten 

    Tighten the bolts to 5 N.m (44 lb in).

    Fig 1: Installing Sight Shield Retainer Bolts & Retainer
    G02116322Courtesy of GENERAL MOTORS CORP.
    NOTE: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
  2. Install the intake manifold sight shield to the retainer.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

    Fig 2: Installing Intake Manifold Sight Shield To Retainer
    G02116323Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals